Step 1
Park the Honda in an sector that allow you sufficient space to to remove the rotor. Seek the place on a relatively dish surface, in a dry area, far from going beyond traffic.
Step 2
Loosen the lug nuts on the Coil or wheels that you to envisage to repair, with the tire iron.
Step 3
Place the lifting jack under the braces of the Agreement and elevator the vehicle. Place jack stands under the frame, and inferior the convey onto the stands. The tires on the Honda would have be free space of the ground while the convey is rest on the jack stands.
Step 4
Remove the lug nuts and traction the wheels of the Coil bolts.
Step 5
Remove the gauge by Elimination the two gauge bolts the 17 mm wrench. The gauge bolts are found on the side of the gauge closest to the braces of the vehicle. traction the gauge from the rotor.
Step 6
Pull the rotor of the Coil bolts. If the rotor is stuck on the Coil bolts or the direction knuckle behind it by rust, jet the connected sectors with chain lubricant. If the rotor is always bound to the vehicle, use a hammer to tap the back side of the rotor until it is free of the Coil bolts.
Step 7
Spray the new rotor with brake cleaner. rag the rotor with a towel to to remove the packing oil and the brake cleaner. Place the new rotor on the Coil bolts of the Accord. to make sure that the going beyond inner ring of the rotor (the top hat section) is coating outward.
Step 8
Place the brake gauge around the new rotor. To replace the gauge bolts and to tighten them with a 17 mm wrench.
Step 9
Place the wheels on the Coil bolts and screw on the lug nuts. elevator the convey with the jack, to remove the jack stands, and inferior the convey to the ground. to tighten the lug nuts with the tire iron.
