Step 1
Set the parking brake and opened the cap of your Altima. Let the Engine cool if the car has summer driven recently.
Step 2
Locate the crankshaft probe on the front of the engine block on the driver's side. to remove the wiring harness of the probe by traction the connector with share by hand. pushed the wiring to one side.
Step 3
Spray penetration fluid on the Casing of crankshaft sensor possession bolt and to leave it work in for a few minutes. to remove the possession bolt in a In the contrary direction of the needles of a watch direction with an adjustable wrench. Set the bolt aside.
Step 4
Pull the probe from the engine block by hand. to avoid prying the probe out as the engine block can be damaged.
Step 5
Make sour the new probe has a brace installed at the tip. to install a new brace (included with the sensor) use the instructions that come with your new Casing of crankshaft sensor.
Step 6
Push the probe into the engine block, being careful to line up the hole in the Support flange of the probe with the threaded hole in the engine block.
Step 7
Thread the probe holding bolt through the probe mounting attach and in the engine block. Place a Couples wrench on the bolt head and to tighten it to 105 foot books in a in the direction of the needles of a watch direction. pushed the wiring harness connector back in the probe until it is entirely seated. end the hood.
