Step 1
Remove the battery cables of the battery with a wrench.
Step 2
Locate the probe at the Back of the Roll head on the driver's side of the engine. The probe is located at the top of a circular black housing, which is fixed to the Roll head with three bolts. A simple wiring harness Catches into the top of the sensor.
Step 3
Disconnect the sensor's wiring harness by traction the catch at the end of the harness out of the sensor.
Step 4
Remove the sensor's simple mounting bolt with a wrench, then traction the probe out of the top of the housing.
Step 5
Insert the replacement probe into the housing, then to install and to tighten the sensor's simple mounting bolt. The probe need only be tightened until it is snug--over tightening the bolt can Too bad the sensor.
Step 6
Plug the sensor's wiring harness in the élém. élect. fitting on the sensor.
Step 7
Reconnect the battery cables to the battery with a wrench.
