Reset the Computer on a 2001 Ford F 150

Sponsored ADS  

  • Step 1

    Locate the OBD port on your Ford F-150 to the left of your fuse panel cover in the driver side foot well.

  • Step 2

    Plug the OBD catch from the OBD sweeping tool in the OBD port afterwards to the fuse panel.

  • Step 3

    Turn the lighting key to the "II" position and makes an attempt for the tool to To seek the codes. Once the tool has sought the codes, makes an attempt for the tool the free space the codes. When the codes are clear, your Control engine light go out. At this point, the computer be reset.


    		•

    Sponsored ADS
     

    Remove the Oil Pan From a 2003 GMC Sonoma | Replace a Serpentine Belt Tensioner in a 2000 Dodge Neon | Replace 2001 Ford F-150 Brake Pads | Read a Manifold Gauge | Replace the Crankshaft Sensor on a 1991 Chevy Lumina | Replace 2002 Intrepid O2 Sensors | I Know If It Is My Car Battery or My Alternator | Install a Serpentine Belt on a V-6 Mitsubishi | Replace a 1993 Trooper Oxygen Sensor | Buy a Hood to a 1995 Ford Mustang | Tighten the Belt Tensioner on a 1996 Taurus | Change a Serpentine Belt on a 2003 Chevy Silverado | Fix the Gas Gauge in a 1992 Ford Ranger | Replace a Taillight on a 1997-06 Nissan Altima | Adjust the Ignition Timing in a Ford Mustang 50 | Replace the Front Wheel Bearings on a 1999 F-250 | Troubleshoot a Focus Ignition Coil | Change Oxygen Sensors on a 1987 Chevrolet | Check Compression on a 22RE Engine | Replace a Turn Signal Bulb in a Ford Focus | Remove the Front Rotor on a 1988 Ford F-150 | Change a Saab Oxygen Sensor | Install Disc Brakes on a 1963 Nova | Remove the Door Panel on a 2002 Chevy Blazer | Remove the Headlight on a Lexus GS300